Replacement UV lamps for all brands

Tue, 30 Jun 2026 00:33:43 +0800

On the press floor, a UV lamp failure is more than downtime. It’s scrapped substrate, color density drift, and the panic of trying to claw back cure energy before the next job. Original lamps are expensive, lead times can be brutal, and a mismatched replacement can leave you short on peak irradiance—giving you uneven cross-linking and adhesion problems. We built replacement UV lamps for all major brands to restore the intended spectral output and cure profile, so the press keeps running and results stay repeatable. What matters, technically These are true-drop-in replacements across major press platforms, with tight control of spectral output at 365nm, 385nm, and 405nm, depending on the system. Output stays stable because the mercury vapor fill and quartz envelope are controlled, delivering consistent peak irradiance and cure energy density (mJ/cm²) across the full arc length. Reflector geometry and dichroic coatings are matched to the OEM profile, which cuts stray IR, maximizes UV delivery, and keeps substrate temperature in check. Rated lamp life is 1,200 hours, with verified output retention so photoinitiators still trigger reliably. Power, voltage, lamp body dimensions, and connector type are spec’d to fit without modification. Why this plays in offset, flexo, and screen Cure comes down to spectral match, irradiance, and dwell. These lamps restore the original dose-rate curve, so ink films cure through without residual tack—and dot gain stays under control. That means fewer rejects, consistent gloss, and the ability to hold higher press speeds without chasing cure. You also save energy by keeping reflector efficiency intact and avoiding the output decay that forces operators to slow the line. Things to know before you swap Installation is straightforward, but verify connector pinout and igniter compatibility before you pull the trigger. check reflector condition, too—pitting and oxidation will kill output even with a new lamp. After installation, run a spectral radiometer baseline to document irradiance and dose, and keep a running count of lamp hours so you can replace on time. Some presses need ozone-free variants. Specify your ducting and cooling setup so we ship the correct lamp for your rig.

All on UV Light Zone

Replacement UV lamps for all brands